Have a 24' Carolina Skiff 2400 Offshore. With the trailer, it measures 32'. The enclosed storage I have is 32'. With the motors trimmed up and the "resting plate" switched down on the motors, I cannot get the doors closed. If I trim the motors down (about 6" off the ground), I can get it in...
1992 88hp Johnson
Had a problem with a consistent stream of water running through the motor. Changed the impeller. Hook it up to a hose and water runs though like a charm. Get on the water - nothing.
Seems to be fine when the water is being forced up into the motor via water hose. But...
1992 88 hp Johnson
Is the Vernatherm the device that sits just about the spark plug that has a wire attaching to where the tilt/trim relays are housed?
1992 88 hp Johnson. Motor will turn over and over and will not kick in. Positive connection on the battery started smoking after about 30 seconds of trying to start...stop...start....stop.
1992 88 hp Johnson -
Bought it not too long ago. First time out was working fine. Put the motor in idle and the rpm's stared climbing. Put it back in gear and motor made a hard thump. This did not happen everytime I put it back in idle. Maybe about 40% of the time. Boat had some gas in...
I am tyring to learn how to do this so that I can change the impeller. Took out the 4 bolt/screws (2 on each side) on the bottom side of the motor. Nothing budging. Is there another screw that I take out? Do I mess with the gearcase trim tab at all and that screw?
Got a 92 model 88 hp Johnson that does not shoot water out of the pee hole consistently when in idle. Give it a little gas and get going = get a good stream. Am I looking at water pump problems?