Recent content by cslaufer

  1. C

    Pre Alpha Lower Unit, Will it Fit??????

    Hi I have a 1990 Mercruiser V6 driving a Alpha one Gen 1 outdrive, now here is my issue, I bought a new Aftermarket (sterndrive inc.) Lower unit off eBay from a ebay shop "boatsunlimited" Based in NY. It cost me $695 plus $200 air express to Brisbane Australia, anyway 7 weeks later Still no...
  2. C

    How does this Camshaft Spec's for a 350....

    Hi, I'm repowering my bayliner 2955 which had 2 305 in the back. <br /><br />I have just bought 2 new Vortec 350's (marine spec) <br /><br />The engines are running outdrives but note the exhausts are running through hull to increase flow. <br /><br />Fuel is delivered by 600cfm Holley's on dual...
  3. C

    Omc Cobra Outdrive Help Needed

    Hi, I have just began to rebuild the upper unit on my 1988 omc cobra 5lt 230hp. I bought the books and I have all the parts. I'm not new with rebuilding outdrives I'm just looking for someone who Know's what the pre-load on the bearings should be on the yoke and waterpump shaft bearings and the...
  4. C

    What Propeller design would you use???

    Hi, I have a 2950 Avanti Bayliner, its weight is 7400lbs. It has just been repowered by a pair of Vortec 315hp SBC, their driving OMC Cobra Outdrives with the 5.0lt Gears 21:18 (or for you Mercruiser Enthusiasts it has a ratio of ap. 1.59:1) <br />Do you think that I should 3, 4, 5, blade props...
  5. C

    OMC Cobra Propeller Choice Power Up

    Hi all, I've just Imported a 1988 Bayliner Advanti 2950, Powered By a Pair of OMC Cobra 230hp 5Lt GMC from the USA to Australia.<br /><br />When she arrive the propellers that were on her were gone, some one stole them, anyway after completing compressions test on both the motors I decided to...
See more
Top