I have a 94 Tracker with original single axle trailer...the bearing buddies seem to be a part of the actual shaft that the hub rides on. I pulled the hubs and repacked the bearings by hand today since a small amount of water came out of one side when I hit the bearings with the grease gun this...
I plan to replace my aluminum bass boat in the next year or two due to some stern corrosion. The boat has a 40hp 4 cyl 1994 Mercury outboard that still runs good so I'd like to move it to the new hull to save some dough. Were can I get a new electrical harness for the engine ? Do they come with...
I have a Tracker bass boat with a 1993 40 hp Mercury serial# 0G083026 model# 1-040312PT.
What can you folks tell me about a bouncing tach needle ? It will seem to work ok some times and then suddenly it goes bonkers and bounces between 2 and 5k rpm. The gauges are less than a year old and are...
I am trying to figure out why the tach on my boat has stopped working. I have a 94 Mercury 4cyl 40hp Pro Series engine on a BassTracker aluminum bass boat.
How can I find out what types of voltages I should be seeing on the cable running from the motor to the instrument cluster ? There is no...
I have a 1993 16' V16 Aluminum Bass Tracker. On the exterior of the stern wall I see corrosion pits eating through the aluminum. I don't see this anywhere else on the boat, all of the other walls both interior and exterior are fine. There are about a dozen spots scattered around the stern wall...
