Recent content by D5GT

  1. D

    V6 2,7L Looper 1 good, 5 weak spark (-86/87)

    Is there real problem?<br /><br />I'v got only one good spark<br /><br />"checked spark and it can't jump a 7/16 gap, only about 1/4, ,using champion QL77JC4"<br /><br />Engine runs but I think this isn't good...<br /><br />Also every wire "hits spark to nails" when i remove boot from sparkplug...
  2. D

    How do I know wich V6-block? (183 or 165 cu.in)

    Where I should find and what numbers or is there some other visible differences?
  3. D

    -89 / 225 / V6 looper's specs

    Is there any internet source for the specs?<br /><br />Most important, recommended RPM
  4. D

    -89 225/Trim works, stops and just Clicks...

    Hello, I'm a newbie here, I'v read a lot trim/tilt topics... but no similar case found.<br /><br />When I push up/bown button t&t works fine, after half second to 10 seconds t&t dies. If I push the up/down button again t&t normally just "Clicks"<br /><br />After little while t&t works a bit...
See more
Top