My 1998 9.9 two stroke yamaha is sneezing and stalling at idle.I have cleaned the carb twice using carb cleaner and compressed air.I also changed the fuel filter ,primerbulb and gas line,and switched tanks emptying the spare one out and refilling with fresh fuel.Still sneezing .It runs good...
My 1997 9.9 yamaha has two wires going nowhere under the cowling.Are these for lights?In other words can I hook them up to a 12 volt stern light?
Thanks
Dan
I have a mid nineties nissan 5hp that under a load in gear revs up and looses thrust almost like its popping into neutral but if I slow down and go easy it will get me home
Any Ideas what this could be?
Thanks Dan
I have a 97 9.9 yamaha two stroke that I'm replacing the water pump on .The old impeller was destroyed when I took it apart so I couldn't tell which direction the vanes were bent into the cup.Can someone tell me which way this goes in?<br />Thank you <br />Dan
My ds600x was fogging up so I sent it in to Raymarine for repair. They sent it back saying they checked for moisture damage and there was none.They treated inside with antifog and added dessecants.I was under the impression that these were sealed units so I called and asked someone who was some...
I have a 94 5hp Nissan I'm trying to get running right.It runs great in a barrel but under a load it bogs or shuts down when I cut back the throttle fron wide open.I cleaned the carburator and now I am replacing the head gasket to clean out salt buildup(someone told me this can effect how it...
I'm planning on doing a compression test on my 97 Johnson 150 (not ficht).<br />The compression tester I bought has instructions for a car engine and says you need to ground the wire from the coil.What is an easy way to do this on my motor? Is this something I even need to do?<br />Thanks,<br />Dan
I have a 97 johnson 150 that just started reading 16 volts at idle and 14 with the key on motor off at the voltmeter.This is just after I replaced the vro pump trying to correct a lean sneeze.The only wires I removed was the 4 wire plug to replace the pump.I haven't checked the voltage at the...
