I have removed my engine, Volvo Penta 5.0 Gxi B(F), from the boat and it is sitting on wood blocks. My repair manual does not go into how to mount onto an engine stand. Do I remove the flywheel housing and then use the holes to mount to the engine stand? Any recommendation would be great...
On last trip I was out for a week straight and when the fuel tank got down to about 1/4 the engine would start to run poorly sputter misfire and no longer have the ability to power up onto plane. I limped in and refuelled and after that the boat started fine, idled out of the marina, and ran...
Has anyone set up a fuel flow system on a volvo 5.0GXi to connect to NMEA2000 on a Lowrance or other system ?
I would like to know your process.
Thanks.
Having problems with the gear shifting. This is a Volvo 5.0 GxiB(F)-Sx on a 2002 Seaswirl Striper.
Sometimes the shift lever will bind and not go forward. If I push the little button at the base to bypass the gearshift, then it will go forward and I can increase / decrease the throttle with...
Hi Guys I am working through my winterization of 2002 Volvo 5.0Gxi-Sx.
Today I drained the raw-water side. It was so easy, almost too easy. Can someone confirm I did not miss anything:
1. remove lower cap off heat exchanger and drain.
2. remove hoses off raw water pump and drain.
Thats it ...
Winterizing my 2002 Volvo 5.0GXi-Sx today.
Drained the gear oil and found 1. the drain bolt was super tight, 2. the gear oil seemed to be gray/milky. 3. no metal on the magnet
Looking for procedure to change seals if that would be the diagnosis.
Thanks !
Hello Forum,
The info below is from a demo Mercury Enertia 19P prop. Looking for your comment on this performance. Also a prop recommendation as this is likely not quite the right prop yet. I am using it for offshore fishing generally travelling 30+ miles distance through some decent waves...
Gentlemen I am the new and concerned owner of a beautiful offshore boat with a 270hp 2002 volvo 5.0gxi and the Sx outdrive.
When planeing the boat is shedding a roostertail and some spray is coming into the back of the boat so cant sit in the back seats. Adjusting the motor trim and the...
When I'm at WOT the RPM will come up to around 4600 and it is not constant the needle is fluttering +- 300 RPM either side of 4600. It used to go right up to 5000 and stay there, sometimes slightly higher than 5000 but it would never flutter. Not noticing any significant change in sound or...
The mercury flywheel holder tool MER91-52344 costs $179CDN! Seems pricey? Do most people use the tool when threading in flywheel puller, or is there an alternative? Would an auto tool supplier have a similar (and less costly) tool? I am working on various mercury 3 cyl outboards 70-90HP from...
The only sticker on it says mercruiser 377861. Any ideas what year or HP this would be? Need to know so I can get the proper repair manuals.
Seller said he thought it was a ford 302 in the range of 1974-77.
Thanks
Hi Guys,
How do I hone a cylinder. What tools do I use? Should I be going to a shop or is it something reasonable to tackle? If its not too tough I would like to try it myself. This is for my '87 70HP mercury. Thanks.
Attempting to get this one ready and all sorts of issues but a good one to learn on. Compression is low in top cyl but with oil the comp jumps up so I think this might be stuck rings. Today I tried to run some fuel additive to see what would happen, if it could clear out potential carbon and...
