i have a 1989 evenrude 200 hp omc. the tach failed when i was attempting to start it. it was hard starting and when it finally fired it revved up before i could pull back on the throttle. tach went up then fell back and is now not working. it zeros out when ign is on but won't work otherwise.<br...
i am planning to repaint my 1989 evenrude 200 this winter. can anyone give me some info or tips on-<br /><br />how to remove decals and prep the motor surface.<br />also a little advice on which paint to use sure would help.<br /><br />also can this be done with the motor on the transom
anyone got any advice on how to correct the timing on 1986 mercury 35 horse single carb. it runs great but starts like it is out of time, to low or to high. i don't have a service manual. if anyone knows where i can get one other than a seloc (they don't have enough detail)i would sure...
I have a V6 200hp Evinrude that takes forever to cold start at the dock. sometimes i have to remove the plugs an wipe them off then replace them then it fires right away. It smokes alot initially and clears out. Once it gets going however and warms up, it runs fine. I have had a new vro unit...
