I just got new axles on my trailer. They are 3500 lb square axles and came without any drain holes. How many, what size and what location should the drain holes be? Thanks for any help.
Anyone ever have the drain hose come completely off the fishbox? I left the valve at the in the bilge open and took on massive h2o. I figured out that the hose came off the fishbox and the water was just filling the hull. I tried to put the hose back on and it is about 5 inches too short...
I am in need of the 2 cupholders on the center console of a 2006 Carolina Skiff Seachaser 2400 CC offshore series. I emailed the factory and they got me in touch with my nearest dealer. So far that dealer hasn't gotten back with me. If anyone knows where i could find a couple of these it...
My wife's uncle just bought a "new to him boat". Says the motor revs way to high and thinks it's the wrong prop. Anyone out there with same or similar setup have any suggestions on prop to use. Not my area of expertise at all. Thanks for any help.
Tim
Have lowrance lcx-15mt unit with a lgc-12w antenna. Unit powers up and says "gps module not responding" I have bypassed my extension cable and brought the antenna all the way to the unit and plugged it directly in so I have eliminated a wiring problem. Does anyone know if these antennas go...
Have a boat with twin 2006 150 four strokes. Starboard/right engine only has a little vibration and sometimes a squeak at idle. I can bump it up to 800 or 900 rpm and vibration goes away. Is this the dreaded balancer assy going out? If so how difficult or how much will it cost to get...
Just got a new boat. Need to know how to take the name decals off. Was told by dealer I bought it from that a heat gun would work. Just want to make sure I don't mess the gel coat up. By the way it is a fiber glass boat. Thanks for all help
Tim
I'm about to buy a 2006 boat with twin yamaha 150 four strokes. Anything good or bad about these? I've heard nothing but good for the most part so far. Thanks for any replies.
