Recent content by dewley

  1. D

    Clanton--Thanks--92- 120 Looper repaired

    Hopefully the engine misfire problem is taken care of finally..As said before problem finally happened when I could get to shop for repair. <br />Put on new power pack which seemed to be help and found that new timer base was breaking down at what seemed mid temperature. When heated up the...
  2. D

    Electric brakes--freshwater

    Can electric brakes be installed on a boat trailer launching in fresh water?
  3. D

    Looking for Clanton 0r Almost Retired Again

    Heres scoop on 92 120 looper with miss problem. did test on timer base or sensor coil as book calls it. Green wire was not showing .5 voltage--zip--zero-- went to ohm test everything checked good -- went back to voltage test green wire showed voltage. Hooked everything back up--motor ran on...
  4. D

    peak -reading voltage meter

    I am now needing to do output test on sensor coil page 3-34 of service manual 508147. Cannot get peak-reading voltage meter but since we are only looking at .5 volts is one necessary or will I fry something eletronically in the coil or elsewhere on motor.\Evinrude 120-1992. Yes, I am still...
  5. D

    A Looper ????

    OK, I give up. Can someone tell me why the 120 Evinrude is called a looper.
  6. D

    ATTENTION FORCE LOVERS

    For Sale::Clymer service manual for 3.5 to 140 HP from 1966 to 1988. In about new condition not oily or torn or messed up from careless use. $25.00 and I will pay postage to anywhere in lower 48 states. Contact----sideshooter3@yahoo.com
  7. D

    What trips timer base to signal power pack

    Have tracked problem to timer base connectors where hooks into power pack. Timer base has no signal at one wire to fire plug. This is a new timer base. Problem will clear up at times and run perfect. Had extra power pack, hooked in with same problem. Traced to timer base--replaced that same...
  8. D

    How to tropubleshoot timer base?

    On a 120 hp '92 Evinrude, how do you properly diagnois a timer base and what proper tools should be used??
  9. D

    Rude 120- 1992--timer base-more problems

    Need temporary help--manual on order--in meantime here is my problem. Have been fighting a missing cylinder ignition problem since vacation--during vacation had motor problem of which power pack was checked-it was ok, checked wiring from timer base. Voltage probes thru multiplug connector at...
  10. D

    Thanks,-clanton and WildeOne

    Appreciate the reply and advice from both. I wil be taking the 120 to the shop for timer base to be installed. I had enough tools I thought, but, the socket I had to remove flywheel would not fit into recess of flywheel, enough said on that subject. Usually these projects go downhill from a...
  11. D

    1992 120 4cy Evinrude

    I have a timer base and need to install, after removing flywheel is this going to be very complicated where I should take to a shop for a 2 week wait or can it be replaced with regular tools, how about setting timing and such as other small details as needed. I do not have a manual at present...
See more
Top