Hello all, I have an Evinrude Lark 40 HP. The model #35520 and the serial #06070. I believe this motor is a 1960. I was wondering if anyone knew of a power tilt/trim option that one could bolt onto this motor? I know of the CMC option but don't like the added weight and I'd like to keep somewhat...
Hello all. I was wondering if anyone has any input on retro fitting a tilt trim set up to my 1960 40 hp? I was wondering if a 1970 60hp 60073d evinrude tilt/trim assembly would work? Any help would be greatly appreciated. Also I'm trying to spend less than the CMC model. My model number is...
Hello there, I was wondering if anyone knew where I could get a throtle/gear shift box for a 1960 Evinrude Lark 40 hp? Or will any one work? The one I have now doesn't seem to be working properly with the proper length cables for the motor and everything. Thanks.
Hello all, I was wondering if anyone had any ideas about where I could be leaking my lower unit oil to? I have checked the lower unit for cracks and I seem to be good there. Anyone know anything about the drive shaft seal on this motor? I.e how much would it cost part number? or any other places...
Hi all, I'm wondering if anyone knows where I can get a drive shaft seal for a 1960 Evinrude 40 hp motor? I posted something a while back about loosing all my lower unit fluid every time I drove the boat and someone suggested the drive shaft seal is bad. Any suggestions? Thanks!!!
Hi all I was wondering if any of you have seen anyone retrofit power trim to a 1960 - 1970 40 hp Evinrude? I have a perfectly good running motor, I'd just like to get some trim for this motor. Thanks for any help.
-Dickinson
I have a 1960 40 hp evinrude that seems to be loosing all the lower unit oil in it everytime I run it for a few minutes. I cant tell where it's coming from? Any ideas? It didn't start doing this until it came back from being stored outdoors this winter. Something cracked? or just a gasket...
Hello all, I'm looking to find out if anyone knows where or how I can retrofit power trim to my late 60's to early 70's evinrude lark lll motor. Thanks for your help!
I have a 1969 40 hp evinrude outboard motor that I have gotten excellent feedback and help on getting it going, I need your help once again. I Have had it running good and decided to put a little sea foam in a tank and ran it through and it was all good. Then I put the right amount of oil in...
Hi all, I've almost got all the issues with this motor worked out thanks to you all. I was just wondering if anyone knows if you can cut out the vacuum cut out switch on this motor. I have filled the tank half full for all my tests and it has been working great. I went to take it for a weekend...
I have a 1960 40hp evinrude that has not top speed at all. I pin the throttle and it goes a bit faster than an idle but not really more than 1/4 speed for a 40 hp. I have good spark on both cylinders as well as fuel coming though the pump. Carb has been cleand and throttle is pinned inside the...
I'm looking for the parts to attach the bottom rim and the top cover to my 1960 40 hp evinrude. I took them off to paint the cover and lost them. Now I have no way to attach the cover to the boat. Any ideas?
