Current visitors

Home
Members

dingbat's latest activity

dingbat reacted to Scott Danforth's post in the thread What Brand of Brake pads are best quality? What do you guys use for quality? with Like.

FYI Magneti Marelli is a Tier 1 OEM parts supplier that supplies almost all automotive brands with parts. they even supply mercruiser...

Jun 3, 2025
dingbat replied to the thread Shot in the Dark Depth Transducer Compatibility.

The hummingbird units he posted above run at 200kHZ which is a pretty typical frequency for sonar units in general. The the thru hull...

Jun 2, 2025
dingbat replied to the thread Shot in the Dark Depth Transducer Compatibility.

Unfortunately, transducer wiring is for the most part proprietary to a specific makes and models. If you have a part number for the...

Jun 2, 2025
dingbat replied to the thread Bouncing Tilt and Trim on Way Down.

Sounds like you have a bunch of air and or water the system. I had both when I replaced the trim motor a couple of years back. Trim...

Jun 2, 2025
dingbat reacted to KVH's post in the thread 200 HP Evinrude/Johnson Carb Kit and Rebuild with Like.

Just got back from the lake. Engine started right up with one turn of the key. No blue smoke. I'm amazed. All I did was as instructed. I...

Jun 1, 2025
dingbat replied to the thread Installing a transducer in an aluminum boat.

The problem with these types of discussions is that “good performance” is subjective. Is holding bottom at speed the standard? Is...

Jun 1, 2025
dingbat replied to the thread Unusual Bilge pump power issue.

A “common” in a DC circuit?. Every ground on the boat must be tied back (have continuity) to a common source (battery post) to prevent...

May 31, 2025
dingbat replied to the thread How much slip does your prop have ?.

Diameter and # of blades have an effect on thrust, but play no role in the “pitch” of the prop.

May 31, 2025
dingbat replied to the thread Installing a transducer in an aluminum boat.

Thru hull is the only way to go from a performance perspective. I’m running a B75M as primary. Holds much better at speed than the GT...

May 31, 2025
dingbat reacted to rolmops's post in the thread Installing a transducer in an aluminum boat with Like.

The ringing would only be an issue if you glue the transducer down onto the aluminum. the way to go is to drill a hole through the...

May 31, 2025
dingbat replied to the thread Installing a transducer in an aluminum boat.

The issue you run into is that the aluminum "rings" and distorts the frequency of the sonar returns. If it's an actual CHIRP or a side...

May 30, 2025
dingbat replied to the thread I used up all my curse words yesterday.

I air down to 20 psi and call it good. No need to go lower if you know what you’re doing.

May 29, 2025
dingbat reacted to Scott Danforth's post in the thread Flap bennet issue with Like.

the whole Bennett power unit isnt that much money. I would just replace the whole thing. the motor and pump combination were not...

May 29, 2025
dingbat replied to the thread What Brand of Brake pads are best quality? What do you guys use for quality?.

Put Hawks Performance pads on my Civic EX. Great brakes, stop on a dime, but dusted heavily. Got tired of the dust and swapped them out...

May 29, 2025
dingbat reacted to Pmt133's post in the thread I used up all my curse words yesterday with Like.

I have to pull the intake on my truck to do 1 bank of plugs.

May 29, 2025

Show older items

Home
Members

Top