Recent content by djarrett

  1. djarrett

    Yamaha 150 etln

    1984 yamaha 150, single bowl carbs stamped 6G401, oil injected. ETLN Im still having a low wot rpm problem. Compression= 100,105,102,102,98,100 respectively The first thing i did was rebuilt carbs. It ran ok for about 1 1/2 hrs then started missing at part throttle again. It still only...
  2. djarrett

    yamaha tach problems

    Can a tach read lazy after it gets old? Got the motor running good but the tach is off. Its a 1984 150 etln. I noticed after a carb rebuild when trying to set the idle the tach stays around 1000rpms. I can adjust the idle up quite a bit before the tach climbs any. Also i was out Sat. fishing...
  3. djarrett

    150 etln bottom carb

    I have recently lost some wot rpm's. With rodbolts help i found and fixed several issues. Installed new fuel pumps, double clamped the fuel connections, bypassed the quick connect and engine mounted filter and cleaned the carbs. A fuel water seperator is installed after the tank and before the...
  4. djarrett

    low wot rpm's-rodbolt?

    1984 yamaha 150 etln. Chasing a low wot rpm issue, i believe its down about 800-1000 rpm. I read the sticky about how to test your fuel line and bought a fuel pressure/ vaccum gauge. Carbs have been cleaned and it accelerates very smoothly, will idle as long as i want it to. Compression is 100...
  5. djarrett

    Help 150 yamaha

    I have 1984 150 ETLN yamaha outboard. When the plugs are pulled out they all look damp, and the top of the pistons look damp(with fuel or oil or both). The insulators have a light tan color and as i understand they should. BUT spark plug #3 always has black soot on it and the top of the piston...
  6. djarrett

    planing out and rpm's

    I recently got a new boat and i have a few questions. This is my second one but my first is only a 14' aluminum with a 7.5 merc. The boat i just got is a 1984 procraft 1650v bass boat with a 1984 yamaha 150 ETLN. This boat has power trim and a jack plate. When i take off i trim my motor all the...
  7. djarrett

    depthfinders

    Hello, i am having a problem with my depth finders and i hope you guys can help. I currently have an eagle finder on the front with the transducer mounted on the trolling motor. I put another eagle on the back recently that i could watch as i idle around. They work great if only turned on one at...
See more
Top