I have a 1987 50 Hp Force outboard. The drive shaft is worn just below the water pump. I would like to repair the worn area. Do I use J & B Weld, Braze or weld the drive shaft? I have tried flipping :) the shaft, but the ends are different.
Force 50 1987 spring gasket found around drive shaft
I removed my gearcase to replace the lower shift rode seal because of shifting problems. When I removed the gearcase I found a metal spring seal around drive shaft. This metal spring seal was on the outside of the water pump. Is this...
I have a problem with my Force 50 HP (Model 507X7C Year 1987 with Prestolite CD ignition) is not creating a spark on either cylinder . I have been following the Clymer manual to check out the stator. I purchased a DVA for my meter, but it only reading the same (12 volts) with or without...
I have a problem with my Force 50 HP (Model 507X7C Year 1987 with Prestolite CD ignition) is not creating a spark in either spark plug. I have been following the Clymer manual to check out the stator. I purchased a DVA for my meter, but it only reading the same (12 volts) with or without...
