I can probably pull the whole assembly out through the back however it is pretty tight back there. Attached is a picture of the control in the same boat I have and a diagram of the OMC controller I have.
I am looking to see if I can get a little better fuel economy without sacrificing too much performance. From what I have read, switching from a 3 bladed prop to 4 bladed prop may do this.
The boat is a 1998 21 foot Chris Craft bowrider approximately 3500 lbs. with Volvo 5.7 GSI with an SX...
I am looking for some opinions/advice on the exhaust flappers on my 1998 5.7 GSI with an SX Drive.
I have removed the risers for inspection and also wanted to check on the flappers. From what I can tell, the flappers appear to be in good condition but they do have a little resistance when I...
My Volvo SX drive was leaking oil into the U-Joint bellows. I decided this was something I didn't want to tackle myself so I took it in to get replaced. When I picked up the drive I looked at the repair order and there was not a new pretension sleeve on the list of parts replaced. I asked the...
Re: Outdrive Tilt leaking down
Just posting a follow-up in case anyone is interested...
I decided to go with the Sierra 18-6806 aftermarket pump. I made a new bracket for the pump and bracket for the relay. The new pump solved the problem with the drive leaking down.
Attached are pictures...
I have a 1998 OMC/Volvo Model 57FCPBYC. It seems this is pretty much a Volvo I/O.
I have posted a couple of questions in the OMC forum with no responses. Should I post these questions in this forum instead?
Dave.
I am replacing the raw water pump impeller on my 1998 OMC/Volvo engine 57FCPBYC and have a couple of questions.
1. The new impeller came with 2 small round rubber disks. I took out the old impeller and it has one disk on the open end of the impeller. In the manual it does not show to use...
I have just purchased a 1998 chris craft with an OMC/Volvo engine 57FCPBYC. I have discovered that the outdrive tilt leaks down. The drive seems to trim up and down OK, it just slowly lowers by itself. I don't see any external leaks. Is there and easy way to tell if the problem is in the pump...
