It has 2 bench seats I'll get some pictures tomorrow not sure if there riveted to the sides though. It was a Peterborough that's all I know because u can see it faintly on the side
Hey I just picked up this 14 ft aluminum boat for cheap I'm lookin to take off the closed bow to open it up I was wondering if this would cause issues. Boat has a 9.9hp and want to use it mostly for fishing smaller lakes.
Gear lube was about 1/4 water when I checked flushed it out with gear oil until seals come to try and prevent corrosion.
Everywhere I look for parts say unavailable for my year would newer seals and such work on a older model?
OK I got idle set nicely but now under throttle it will miss randomly every few seconds. New plugs good spark on both plugs, compression is around 120 both cylinders, took carb apart and cleaned again. It will run great for 10-15 seconds then a hard miss and run great again over and over
First outboard after I get it warm do I go leaner until it coughs and then turn it richer 1/4 turn or do I go richer? Or do I just play around until it's highest rpm
Hey I recently got a 1977 9.9 johnson carb was gummed up so I took it apart and cleaned I didn't take not of the turns the rich and lean knob was at. Does anyone know how many turns from seated it should be ?
