Hi. I have a 1996 9.9 Oh005284 Mercury outboard.. I need a new fuel pump,but I can't seam to be able to find one anywere. can anyone tell me where I can buy one, Thanks
Re: macerator pump out at home
There is not any room to put it in the boat, cant even get to the tank without removing the motor. I found this on the forum. Looks like it woud work..
Hi do'es anyone have a picture of a home made pump out for home use? There is not a pump out station in my area so I need to be able to pump out my holding tank at home. Can you put a macerator pump on the outside of the boat and pump sewage out of the boat into my sewer dump at home?
I have a 1993 rinker 260, with the 454 engine and the mercruiser out drive. Took it to the lake and it ran good at ideal and not bad at full throttle but seamed to bog down in between the two. any ideas why? The exhaust bellows came off of the outdrive do you think bellows being off had any effect ?
HI, just got my new repair manual in the mail. (seloc) not a very good manual, also got the online stuff dido's.. Anyone have a webpage for a good manual for a 1993 rinker mercuiser bravo two 454 ?
I have a 1993 rinker 260 fiesta vee with a 454 mecruiser brovo two while changing the out drive gear oil I found that there was a little gear oil on the bottom of the reservoir, Do you think this is a problem that I need to fix right away or can I just keep it full antill winter and change it...
HI. I have a 1993 brovo two and I seam to be missing a part. The part I'm missing is the part that hooks on the outdrive from the transom, there is a large hose sticking out of the transom but there is nothing that would hook to the outdrive exhaust when the motor is lowerd. Can anyone identify...
I started my 351 ford 235 omc outdrive at the house with the hose hooked up, ran great. ( no cooling problems ) took it to the lake and it ran well. but after about 10 min the heat gauge started to rise at low speed. So I gave it some gas and it came down to normal, thought it was going to be OK...
I’m starting to work on the brake symptom of my 1993 Mastercraft trailer and when I took the wheel's off I found the brakes were filled with Grease . It is all over the brake pads. The trailer has bearing buddy's is this normal? Or is it because the rear seals are bad?
I need some help. When I turn on the key switch on my boat the needle for the heat gauge go'es down instead of staying still or going up a little.. I'm trying to get the boat ready for the sommer but I don't dear run it to long in fear of it getting hot. I have only ran it for two or so min...
