It appears that it would require changing the flywheel to have a gear for the starter. The solenoid mounts on the starter flange. I know that there is no need for the wiring ( as long as one is careful to make sure the motor is out of gear) nor the charging system. It would be just fine using...
I recently purchased a 2008 Honda BF15D that has manual start. Because I have an extremely bad shoulder due to an old injury I would like to convert it to electric start. I have the wiring needed c and have found a good used starter, However I checked and the flywheel does not have teeth on it...
I have tried that and no luck. I guess I will have to go old school and find out which cylinder is top dead center when each set of points is opening. Really was hoping to avoid pulling the flywheel again but seems like I will have no choice. Thanks for your answer.
I recently came into a 1975 15hp Johnson outboard. It had been in storage for 18 years. I went ahead and replaced the driver coil (under flywheel) both condensers and both ignition coils. I also filed and set the points. In the process of changing the driver coil I found the replacement coil...
I am replacing a charge coil on a 1975 Johnson 15 hp. The replacement coil (oem) has the blue and white wire coming out of the opposite than the one I am replacing. Does it matter if the wires are reversed or not? I want to mount the coil with the wires coming out on the bottom of the coil like...
Was wondering if anyone could steer me in the direction of an owners manual for my new (to me) boat. It is a 1989 Model 1620V. Any help would be appreciated! Some photos for identification attached.
