FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
In Other News . . .
You will notice a few enchancements to the forums to make your experience better. These include: Email Notifications, Thread Previews, Thread Starter Notation, and Emoji Options on the 'Like' icon. . .
Additionally, the merchant portions of the website have been updated and are now operational. . . . Check out iBoats for all your boating gear.
i have a volvo penta 2006 5.7 osi-ef with MPI injection with a carter 21545138 pump. i am having issues with the low pressure pump not filling the reservoir.
i have bi-passed the anit-siphon ball by using a small gas can so i know i have good fuel flow to the pump.
i put a small electric pump...
in the process of re-installing my engine, i broke the y-pipe. i purchased another y-pipe that had the same part # stamped into it and it doesn't seem to be right. of course, the old part is long gone to a local scrap guy that drives around the neighborhood so i can not measure them to check and...
i am looking to repower my 5.7osi-ef to a 6.2. do i need to have a local engine shop with a dyno do the programming or is there some where that i can send my ecm? thanks for any and all advice
i am looking for the water plug on the port side of the outdrive. it is located in the upper unit under the cobra medallion. i have looked all over and can not locate my original one. i can't seem to find one on any of the diagrams, just the medallion itself. any help would be great.
thanks
duane
i bought a smooth running two piece rear seal motor to repower my 87 cobra drive with a one piece seal. of course the bolt pattern is different. has anyone used this coupler, sierra 18-2171? i have been doing a lot of reading and this seems to be the part i need but would like confirmation that...
i have an 87 bayliner with a 305 omc cobra. can i use the coupler from a onepiecesealcrank on a two piece seal crank? i bought a complete running 350 and turns out it has the two piece seal. according to a friend of mine,who knows more than i when it comes to these boats,he seems to think that...
i am in the market for an 87 omc 350 crate motor. who should i buy from? anyone with recommendations as to where to buy from would be greatly appreciated. i know you get what you pay for, but the range that i am seeing is 1200 to 3500 for reman and upwards of 6000 for new. buying from the...
well, i just got my new project home yesterday and gutted everything today. bad news came when i got everything cleaned and cleared out of the way, my 305 block is cracked, visible with the naked eye so it is junk!! i know i can use a short block from a truck but i need to know which one i...
