my boat had a 1969 johnson 55hp on it, i replace with a 1971 evinrude 100hp. will the tach that was on the 55 work on the 100? tach is an airguide model 1024. if it will work what setting do i use? thanks
i just changed outboard motor on my boat. went from 1969 55hp johnson to a 1971 100hp evinrude and now it lists badly to the left, have adjusted trim tab fully to the right as it was pulling right without much change. when i pulled the 55 off there were two fender washers between transom and...
i put a 1971 evinrude 100hp electric shift on my boat. am useing type c lube. running with the muffs on she shifts into and out of all gears properly. when i put her in lake it would not go into reverse. at idle prop would spin in reverse but under power it wouldnt engage, but you could hear it...
i have a 69 johnson 55 hp that misses bad when accelerating slow, has a slight miss at other speeds. seem worst at end of day when in no wake zone. checked last night after loading and water manifold was fairly warm and top of engine-flywheel above stator was HOT. have replaced water pump. also...
i have a55hp johnson 1969 hydro shift. starts great, no hesitation on accelleration,everything seems good until i get back to dock. when in no wake zone it dies at low speed. it started as a miss, 2 trips later it would stall but restart, next trip stall and no restart. i have replaced all...
i am repainting deck,gunnels and splashwell on my 1976 crestliner nordic 17. never done this before and would like advice on entire operation, stripping, prepping and paint. any help would be greatly appreciated. bottom half of boat has already been done. can i lightly sandblast old finish off...
