Recent content by dulind

  1. D

    1973 evinrude 135hp

    first i want to say thanks to everyone that helped me get my ignition problem sorted out, replaced my timer base and motor runs like a charm, but as i said this is a new boat to me and i am having a prop problem i think, it is "spinning out" at high rpms (around 4500) it is not a power trimmed...
  2. D

    ignition woes on '73?, 135hp evinrude

    this is a motor i recently purchased with the #2 and #4 cylinders not firing, I have determined that this is due to a faulty sensor coil which can only be corrected by replacing the 'canned' timer base assembly. However after removing the flywheel i have a clear view of the sensor coils that...
  3. D

    ignition woes on '73?,135hp evinrude

    this is a motor i recently purchased with #2 and #4 cylinders not firing, i have determined that it is a faulty sensor coil via resistance test, and the remedy is to replace the 'canned' timer base assembly, however when i removed the flywheel i have a clear view of the sensor coils that seem to...
  4. D

    '73?, 135hp evinrude starflite

    this is a motor i recently purchased with the #2 and #4 cylinders not firing, i have determined there is a bad sensor coil and i was under the impression that this could only be remedied by changing the "canned" timer base assembly. However after removing the flywheel i have a clear view of the...
  5. D

    '73?-135hp evinrude

    this is a motor recently purchased and it is not firing on #2 and #4 cylinder, i have determined that there is a bad sensor coil. This is where my questions start, i have removed the flywheel expecting to see a canned timer base assembly, but after getting the flywheel off i have a clear view of...
  6. D

    '73-135hp evinrude torque specs?

    anyone know how much torque should be placed on the flywheel when reinstalling it on this motor?
  7. D

    ignition problem on '73-135hp Evinrude

    i recently purchased this motor and it has no spark on #2 or #4 cylinders, trying to do the swap and switch trouble shooting procedure i switched the #1 and #2 sensor wires on the powerpack and began getting fire on #2, does this indicate that i have two bad sensors or is there something else...
See more
Top