Recent content by Dunk50

  1. D

    Prop selector HELP

    I have been trying to make sense of the prop selector and not having much success. I just bought a 2013 Lowe FN160 with a 50hp 4 stroke merc. The aluminum prop didn't last very long. Looking for a stainless prop. Boat is a side console deep V and pretty much std i everything else. Can anyone...
  2. D

    Indiana Beach Lake Shaffer Monticello Indiana

    I am looking to spend 4 or 5 days at Lake Shafer near Indiana Beach, in Monticello, Indiana. I am looking for a Hotel or lodge or even a cottage but we are not looking to cook or clean so must have housekeeping. Wife says what is a vacation if you still have to cook and clean. I AGREE! now...
  3. D

    Which Prop None at all with new motor

    When posting a question about propellers, you cannot get a reasonable answer unless you provide the following information in your post: Items 1-4 are essential for meaningful response to most questions. 1) Performance issue you are trying to correct. (good all around prop) 2) Current prop...
  4. D

    Hollow Transom

    Hi guys, I have been lurking for a while. Read a thread on a question that i am interested in also. I just bought a new Tracker 1754 and a new 60 hp Merc tiller. The thread I read was about the Tracker transom being double or what appears to be double on the inside and double on the outside with...
  5. D

    Impulse 2400 and 2800

    Does anyone know if the power cable, tranducer and temp are interchangeable. My 2400 is shot and there is a 2800 available without wiring?? Any ideas :eek:
  6. D

    Help on Fish Locators

    Need some advice. I have a Humminbird 300TX and a Humminbird 3D wide view. I also have two Garmin 160s. I wanted to go with the Garmins so that I would only have to learn one because I put one on the fornt and rear. The 300TX and the 3D are different from each other. The problem I have is I have...
  7. D

    Propeller Knowledge

    I don't have any! I have a 1993 Evinrude 60HP tiller with a 13 3/4 X 15 aluminum prop. I was looking on e-bay and don't have any idea what prop will fit. There are many that list omc and evinrude. I was told that I might have to step up to a 17 pitch and think I should. What is the criteria for...
  8. D

    60HP Tachometer

    I have a 1993 60HP Evinrude Tiller. I do not have a console but do have room on the side of boat where switches are to install one. I can't seem to find a tach for this 3 cylinder. Would like to know the rpm's with this 13 3/4 X 15 prop. Might need to change for top end. Right now I pop out of...
  9. D

    35 Evinrude id

    I have a 35HP Evinrude that I think is an 82-83. It is a long shaft tiller with electric start. The SN is legible but the model # is ???. The best I can make out is Model E3TE1CTS or E35TEICTS. The Ser # is F0296328. I don't know how many letters / numbers the model should have to figure it...
  10. D

    Remote to Tiller

    I have a nice 16' deep v Sylvan I am happy with.It is rated for 60hp tiller. On the other hand the 35 doesn't get it. I cannot find any selection or basically any used 60HP tllers. I have changed some older 30 and 35 back and fourth but how available are the tiller handles for the 60's and is...
See more
Top