Recent content by easygo0

  1. E

    removing screw plug in head for water pressure gauge

    have read all related posts.seems plug will loosen 1/4 turn then gets tight i have worked it back and forth but do not want to snap it off motor is 2002 C40 yamaha was fresh h20 only, any alternatives other than BFH running hyd jackplate need to have pressure gauge.
  2. E

    C40 TLRA hard start ,misses at idle

    Just purchased C40 3 cyl motor that was fogged before sent,has approx 10 hours as per previous owner,installed with brand new 704 controller,key switch and 10 pin wire harness and lcd tach which is at 6 pole setting,when first rigged removed plugs and sprayed little amount of 2 stroke oil in...
  3. E

    2001 C40 TLRA hard start, misses at idle

    Just purchased C40 3 cyl motor that was fogged before sent,has approx 10 hours as per previous owner,installed with brand new 704 controller,key switch and 10 pin wire harness and lcd tach which is at 6 pole setting,when first rigged removed plugs and sprayed little amount of 2 stroke oil in...
  4. E

    will main wire harness work

    have now twin 1986 200 etxj will same main wire harness work with twin 1997 efi s225txrv have analog gauges dual oil tanks.thanks for any replies
  5. E

    1994 merc 30 impeller replacement

    need to replace water pump impeller on 94 2cyl 2stk 30 hp. minimal saltwater corrosion .never had lower unit off on merc done a few v6 yammies and johnsons is thier anything some brilliant merc engineer did that could cause me some problems "Ford has a few if ya know what i mean" Just remove...
  6. E

    yamaha transfer box

    have duel v6 yamahas with manual transfer boxes lockout is lever @ lower station seem to be four boxes having trouble with to much slop in one box need replacement anybody have any sources older boat dont feel like dumping to much $in newer elec box plus rigging time.
  7. E

    fuel managemet sender install

    Any Good Ideas ????? :confused: In the process of installing fuel mgmt senders on 1989 v6 yamahas,seperators and filters are mounted on transom in partial wet area is it possible to mount senders inside motor cowl attached to engine block and route harness with engine harness .wondering if...
  8. E

    Transducer for Raymarine L750

    looking for thru hull bronze transducer w/ speed and temp belive P# M-78923 or B-744v or E-66031 hopefully someone has one that upgraded.
  9. E

    Repower with existing wire harness

    Boat is originally equiped with 1986 200 dual yamahas.Thinking about having 2000 200 SS II yamahas installed can I use existing wire harness with newer motors, harness and analog gauges in excellent cond.
  10. E

    bent prop shaft

    recently hit submerged object at night.next morning went to flush motor and noticed couple quarter size chunks taken out of one blade on stainless 15m prop ,also spun and noticed shaft about1/8"out of true.can shaft be removed and straightend at machine shop, or do i need to open my wallet to...
  11. E

    pole setting on tach

    Have 88 yam 150 etxg,have manual but cant find anywhere in specs for tach pole setting ,sure could apprciate some input,tach is yamaha analog w/ oil warn lamps. thanks :confused:
See more
Top