FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
In Other News . . .
You will notice a few enchancements to the forums to make your experience better. These include: Email Notifications, Thread Previews, Thread Starter Notation, and Emoji Options on the 'Like' icon. . .
Additionally, the merchant portions of the website have been updated and are now operational. . . . Check out iBoats for all your boating gear.
I have a 70's Chrysler boat with an out board engine. I installed a bilge pump in the bilge. When I went to test it, the water just disappears? When I checked it out, I found a hole in the front wall (towards front of boat) of the bilge where it meets the floor (bottom) of bilge. If I keep...
I am trying to replace my manual tilt with a power trim tilt from the same era. It has 4 hoses, 2 cylinders and a pump. I bench tested it already and it is operating fine (picture 1).
I am now trying to install the new power cylinders and I wanted to make sure I am taking the right stuff off...
