It looks/looked like a different piece than the pic I took the day I broke it. Boat is in storage and it will be this weekend before I can pull the old one off.
But to answer your question, I guess I think it won’t work because I haven’t tried it yet. Lol!
I removed the throttle and shift cables from my outboard to clean/rebuild the cards. When I was putting everything back together, I cracked the plastic slide shifting piece that the shift cable attaches to. Motor is a 2000 90hp ELPTO, S/N 0Т106579. I ordered what I thought was the replacement...
You were correct, it wasn’t anything to do with the starter system. Pulled the plugs to see how the engine turns over, along with a compression check. Found a hole in one of the pistons. Dangit!
I have a new to me 2003 Johnson 90hp 2 stroke, problem that I am experiencing is bendix 'kicks' out before engine fully starts. When the bendix falls back down after 1-3 turns of the flywheel, I can still hear the starter turning. I have taken the bendix shaft apart, cleaned and inspected. It...
We just picked up a 2003 Tahoe Q3 F/S 4.3 and it has a 4 blade SS prop on it but no markings of the pitch. It gets out of the hole quickly but will run right past 5000 rpms which is not good. Any insight what the stock prop would be? I’d like better too speed as we aren’t pulling skiers. Thanks all!
I am struggling to find info on my boat. It is a 2001 Palm Beach Whitecap 171 (Whitecap 171 is on the side of the console). I have been to the Palm Beach website but cannot locate the model I have on there (website is quite outdated). I am looking for the weight and gas tank size primarily. I...
Neub here--hope I am posting this is the right forum--
I have a 1985 Mercury 75 and I am wanting to winterized my boat myself (1985 Dixie 175). I found a check list but the only thing that I cannot locate it the block drain screw. I ordered a manual for the motor yesterday but I wanted to go...
I just purchased a boat with the 18802E (Evinrude 18hp). The guy had a push button switch for the electric starter. I am concerned that he has the wiring incorrectly--it actually looks quite messy. Does anyone have any info as to how this is supposed to be wired to a switch then to the battery...
