Recent content by elcamino12sec

  1. E

    new etec's

    Just wondering from etec owners how they are holding up.
  2. E

    75hp Honda Q

    I have to hit the solenoid with a hammer about half the time for the starter to work. Can the solenoid be replaced or is the whole starter that has to be replaced? Also does anyone know a place I can send it to be rebuilt because the 399.99 price tag I keep seeing for starters is just too steep!
  3. E

    Honda 75hp

    what year civic is this motor out of?
  4. E

    Bimini Fishing, please help

    Taking a trip to Bimini at the end of June. Just wondering what to fish for and what tackle I will need to bring. Any help would be great.
  5. E

    recomend my spare prop please

    I am looking for a spare prop for my dt225 two stroke. Where can I find the cheapest spare. The spare can even be one of those plastic props. Just need something to limp back just incase I destroy the main prop, just not looking to spend very much.
  6. E

    Anyone going to Bimini?

    Just wondering if any members are intrested in going to Bimini, will be leaving from Ft lauderdale sometime in June.
  7. E

    Help me pick out a GPS Garmin 540s?

    Hello all, Im currently in the market for a GPS/Fishfinder unit. I hope to take a trip from Ft Laurderdale to Bimini this summer and need Navagation but also want a fish finder too. It was recomended to me to purchase a Garmin 540s. My budget is under 800, just wondering if anyone has any...
  8. E

    Suzuki DT225

    Im about to change the impellar on my 2003 DT225 for the first time. Just wondering if there is anything special I need to know before I takcle the job. ie disconnecting the shift shaft etc.... Any help would be great thanks!
  9. E

    Brass or rubber plug???

    My Family owns a 1986 22' Chris Craft cuddy with an outboard. It has a brass plug that we tighten up with a wrench we leave in the tow vehicle. It is tightened before we leave and taken out when we get home. My question is: My My mother worries that it will fall out and we will sink. We have had...
  10. E

    Muffs or no Muffs?

    When I got my boat back from having the new motor rigged, the tech that did PDI with me advised me to flush out the motor with muffs on the lower unit instead of the hose flusher next to the trim buttton. He stated that by doing this alows the motor to warm up and allow the thermostats to open...
  11. E

    Solas Props?

    I just got my boat back from the delaer, had a new 2stroke 225 Suzuki installed, it has a 14-3/4x20" prop, havent had to WOT yet due to break in, but just wondering if this is a good brand or not? thanks and happy boating.
  12. E

    New trailer purchase

    Im in need of a new trailer. I was wondering if anyone has had any experance with Owens & Sons trailers? They are a local place in Florida. It is for a 22' cabin cruiser, use will be for mainly salt water, their trailers seem VERY well built, anyone out there know any good or bad feed back...
  13. E

    New DT225 just got back

    Well guys, just got my boat back for the dealer with having a new Suzuki 225 2stroke rigged on my boat. seems to be fine, I took it to the lake on the way home and ran well, did not run it hard do to the break in and what not, they said they use 4200 to seal the transom. My question is, its a...
  14. E

    New DT225 just got back

    Well guys, just got my boat back for the dealer with having a new Suzuki 225 2stroke rigged on my boat. seems to be fine, I took it to the lake on the way home and ran well, did not run it hard do to the break in and what not, they said they use 4200 to seal the transom. My question is, its a...
  15. E

    Cat Boats

    My Father is looking at Cat boats, we have always had mono hulls and been very happy. He took a test ride on a Cat boat and was so impressed he wants to buy one in the next year or two, most likely around 26-28 ft. My question is: if they are so great, than why do you never see them, are there...
See more
Top