hey guys just bought a vip 17ft. bass boat the guy giving me a johnson 200 to put on it is that too big i think it will ougt to go faster than the 150 rated for it? its a 1981 good deal i think for 850.00
I replaced the water pump and took her out for the test shes running great but know no reverse. At first the shifter would go into reverse but it went forward slow instead of backward. Know it wont even go into reverse. It stops at neutral. Help please i am going on vacation the 19th and would...
Hey guys i just got given this ski, no motor or title, my next project. I need alittle help to find out specs and to find out how to aquire a title and motor. Im looking for a motor that i can rebuild or do little work to thanks.
Kaw460590582-B these are the vin #s. Also how do i look up the...
I just replaced the water pump and all the thermostat parts I finally put it all back together and hooked up the water and started Her. I didnt see any water yet so i waited a minuite to see if the thermo. would open. Well i waited 4 MIN. and shut it off , pulled the tubes between thermo and...
Hey guys i replaced everything from the whole water pump to the check valve for the vernatherm. All new but i am not getting water to the motor would it be possible that the key for the Impeller fell out of place during assemble and the shaft is just spinning and not turning the impeller.
I replaced the water pump today although i dont have any water coming to the top of the motor. I took off the two hose and nothing so i shut it off before i ruin the new water pump.
I have come to the conclusion that the only way to be happy wiith my boat is to rebuild completly. I would like to tweak and tune motor with performance part. Any help would be appreciated. I am looking for complete engine parts seals and all. THANK YOU 1975 135HP johnson v4 Model (135esl75e)
im putting a water pump on my 1975 johnson 135hp v4 the kit came with an o ring except i cant remember where it goes help please. i wounld like to find a site that has blown up diagrams to look at i used to know a site but cant remember name.
if i take off the head on my 1975 johnson 135hp v4 motor can i get to the edge of the rings . i was told that i may have a bad intake ring although i have 120+ compression any thoughts
i have checked everything cleaned carbs 3 times, good comp. good spark, fuel, I tried sea foam. Still nothing i took it to the lake this morning and under a load it starts to jug imediatly
