FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
In Other News . . .
You will notice a few enchancements to the forums to make your experience better. These include: Email Notifications, Thread Previews, Thread Starter Notation, and Emoji Options on the 'Like' icon. . .
Additionally, the merchant portions of the website have been updated and are now operational. . . . Check out iBoats for all your boating gear.
As you can see in this proline they have these tan pads that are very rock solid that were used to bond the deck to the subfloor. I plan on building my deck by putting 3/4 on the outer edge. I posted on here a while ago and was prompted to keep digging for wet foam, rotten stringers & transom...
I'd like to run low 50s. A 200 is probably a good size. The boat is rated for 150 but my face plate is not on my boat. Is there any legal repercussions for going 50hp over?
I have a 1993 proline 19 footer center console that is paired with a 1983 Evinrude 140HP. The Motor still has the old 17 pitch OMC prop however it is still in fair shape no chips or warps. Under wide open throttle, the boat sits at 5500 RPM. However, my vacuum speedo says 34 mph, and my GPS says...
This is a 19 foot boat with a 10 foot long by 6 foot deck. I plan on putting down 3/4 ply with 1 layer of csm and one layer of 1708 ontop, and 1 layer of csm on bottom. How much polyester laminating resin should this take?
