im looking for the coupler that connects the two halfs of the shift linkage inside of the motor. and where would be a good place to look for one. the motor is an 1965 60hp evenrude.
i have an evinrude fast twin 15 im guessing early 60's model i want to use as a kicker, its got good compression numbers and appears to be in good shape, but it looks like it has the old 2 line fuel tank setup what is needed to convert it to a single line setup?
i think my lower unit is shot. yesterday i ran the motor and it wouldent go into reverse when i got back from using the boat i checked the lower unit and there was watter mixed with the oil. so i changed all the orings i could get to without taking the lower unit off. and i think iv narrowed the...
i have an 1965 evenrude sport four 60 hp i started it up for the first time today. it started first pull (don't have the electric starter hooked up yet) i ran it for about 2 mins on a really rich oil/fuel ratio seems how the motor had not been run in so long shut it down started it back up ran...
http://www.3m.com/US/auto_marine_aero/Bondo/catalog_itemd728.html?itemNbr=209
is this stuff any good? is it good for marine applications? does it have any strength
well im finishing up my transom floor and stringer job motor is mounted back on all controls are hooked up everything is back together other than building some seat bases i dropped the boat off at the the shop for new watter pump impeller and carb cleaning. im starting to think i should have...
is there any local box stores that carry poly resin? like home depot lowes menards? i know that auto parts stores carry it but there stuff is way expensive. only thing i have left to do is a second layer of woven roving and i think im going to be just shy maby a pint of resin knowing how much...
well i'm bedding in my floor tomorrow so its time to start thinking further ahead. i still have a bikini top from my jeep wrangler that i sold about a year or so ago. and now i want to use it to make a top for my boat. i was thinking of using metal electrical conduit as the framing. what are...
im having a hard time wetting out my woven roving. i think its 24 oz cloth if i remember right. well anywhaz my method so far has been to first wet the area im applying the cloth too lay my pre cut peice over the top of the area and then use a dry paint brush or roller to push the cloth into the...
well here is where im at now, i have a lot of stress cracks in the outer skin of my transom. i didn't really notice them till i really got to looking, i also have several holes that will not be re used, it looks like 2 different outboards have been mounted with different bolt paturns. different...
how much fiberglass cloth and resin do i need, iv already biult my transom and installed using resin from the autoparts store and my own saw dust, but i still need to tab in the new transom and glass over the new floor. its a long shaft transom that is 6 foot wide, its an 15 ft runabout, the...
the motor thats on there is an 1961 evenrude sport 4 i picked up an evenrude fast twin 15 of around the same vintage that seems to be in good shape at a yard sale for $10 and was thinking of mounting it as a kicker, i know they would hit if they turned independatly of eachother but i was...
am i going to get hasseled towing an Bayliner ciera 2855 its 28 foot long and 9'10, my truck can tow it just fine im just wondering if im going to need permits and if i dont have them how likley is it i will get in trouble
i know i havent posted here in a while, been to bussy to make much progress on the boat. well anyway almost all of the old wood out just have a thin layer and little peices left stuck to the outter skin, i noticed that the transom outter skin is quite thin and flimsy, that kinda throws a wrench...
