Recent content by FastBoatBronson

  1. F

    Ford Inline6 from car to boat

    Can this be done? Is there an outdrive that will bolt up? How about a jet drive?
  2. F

    Are Electra-shift lower units interchangable?

    I have a model #50173S with a good power head. So I want to know what lower units will work. Thanks
  3. F

    Evinrude lower unit compatability?

    I have model #51073s and it needs the lower unit replaced . Which models are compatible? Thanks
  4. F

    14' tunnel hull speed boat ????s

    I was wandering if anyone has seen a boat like this before or any info they can share with me. It was built in 1969 I think and came with a 115 HP Merc. Short Shaft. When I got it it had no motor. I got a good deal on a newer distributerless 1150 Merc. with built in tilt but it is a long shaft...
  5. F

    IDing year and carb or fuel pump issues

    Ser.# is 3763434 115 hp 6 cyl. Merc. with blue stripe on cover. with hydro. tilt control. What year would this be? What are common issues with these? More specific in area of the fuel system. Im thinking about taking off the carbs and rebuilding and full pump at the same time. Any helpful tips...
  6. F

    73 115hp Merc. wont accellerate

    on land with earmuffs the motor performs as expected but with the boat in water, the motor performs differently. At idle it sounds normal. As I put it in gear and give it throttle it just bogs, doesn't bog down, doesn't accelerate enough to plain out either. Doesn't matter if I throttle slow and...
  7. F

    Can I use a motorcycle engine in my boat?

    I have a 16' fiberglass speed boat hull that I want to convert to a inboard. I've read all the reasons why I shouldn't (thanks), I still want to convert it. I want it to look interesting and different. I believe a V-8 and V-6 both would wiegh too much. I would like to use something like a 1100...
  8. F

    Going EXTREME with my Bayliner

    Without doubt a person will spend days searching and reading excessive amounts of posts and not only get questions answered but also get expert advice, support, step-by-step how to's, and everything else you may need to know. After reading countless posts for 2-3 days, unfortunatly, I still have...
Top