Does anyone have any tips for cutting pexiglass to minimize risk of cracking it?<br />It's for a boat windshield and will be cutting curves as well as straight lines.<br />Thanks
Can pexiglass be heated and bent with heat gun to make windshield on speedboat,or or would lexan be a better choice.<br />I've heard you can cold bend lexan,anyone know?<br />thanks.
I have a 76 merc 110 9.8 hp.<br />Installed new impeller,when started there's lots of water from the tell tale.<br />Drive for about 10 min. and the water flow gets less & less then stops.<br />Shut the motor off then start up and it does the same thing,lots of flow then stops after about 10...
I'm looking for info on old speedboats,lots of info on motors,but is there any for boats?<br />I have a springbok aluminum speedboat and looking for pictures of interior to restore somewhat to original.From early 70's 14 ft.
I'm in the process of repainting my aluminum boat and found a small hole about 1/8 inch in bottom.<br />I guess I found that slow leak I had.<br />Does anyone know what would be the best way to repair this?
I'm in the process of restoring my aluminum speed boat.<br />when I removed old paint I found original stickers under paint but can only make out 2 or 3 letters of decal and can't make out name.<br />It's an old boat and has had the windshield removed and altered.<br />My question is;<br />Is...
I'm in the process of restoring my 14 ft. aluminum boat.<br />I have the boat down to the bare metal.<br />I was wondering if anyone knows the proper paint procedure for painting aluminum?<br />I.e.priming,sealing,painting?<br />Planning on spraying.<br />thanks.
I have a 1976 merc 110 9.8 h.p.<br />The shifter moves and clicks into F.N &R but it stays in forward gear,any info on what may be wrong?<br />Shift shaft is turning.
I have a 14 foot aluminum boat which has small leakage around the seam of the keel,my question is;is there any type of sealant I can put along the seam before I paint the boat that will stick good to aluminum?
I am trying to change the prop seal on my merc,but I am having trouble removing the prop,seems to be seized on.<br />Any suggestions on how to remove a stuck prop?
Merc 350 s/n 1588174.<br />I have a control box with no ignition switch,hoping to hook up electric start.<br />Does anyone know where I can get a wiring diagram to run an ignition switch?
I have a merc 200,sn 7090383.I am in the process of changing oil in foot.<br />I have drained oil,is the small screw about 6 inch above drain the fill?<br />If it is,what's the easiest way to get oil in.<br />Having a hard time to get oil in.
I have an old Evinrude which uses a pressure tank system.<br />I cannot find a tag or ser # on it,is there any place on the motor where I may be able to find some type of number on it to identify it.<br />It's a two cylinder,says fastwin on it.I'm guessing in the 10 h.p. range judging by the...
