Recent content by fcryon

  1. F

    '68 9.5hp slow speed problem

    I can't figure this one out. My motor has good compression, I've replaced points and condensers, the coils are strong, and I just disassembled the carburator, soaked it in carb cleaner, and rebuilt it. She fired up on the second pull. The strange thing is that it runs great WOT but sputters and...
  2. F

    '85 90 hp starting problems

    This weekend while out on the water I turned off my engine and when I went to start it again there was nothing. I used a jump wire to bypass the solenoid and the starter motor kicked over and got me going. My concern, before I just assume that the solenoid is shot, is that the choke would not...
  3. F

    '64 evinrude 9.5 high end problems

    I can't seem to get full throttle on my 9.5. I replaced the points, condesers, and plugs and am getting strong spark. I've also replaced the valve seat and the needle valve in the carb. When I open the throttle up it just doesn't go much more than 1/2 speed and after awhile seems to flood out. I...
  4. F

    90 hp prop shaft seals

    I need to replace the prop shaft seals on an '85 90HP evinrude. I'd like to know if a special tool is required to remove the prop hub and thrust bushing before I start the job.<br /><br />Thanks
  5. F

    '85 90 hp drive shaft seals

    I need to replace the drive shaft seals on an '85 90HP evinrude. I'd like to know if a special tool is required to remove the prop hub and thrust bushing before I start the job.<br /><br />Thanks
  6. F

    power trim for '85 90 HP Evinrude

    I've purchased a used power trim unit for my '85 90 HP Evinrude and would like to rebuild the hydraulics before installing it on the motor next spring. I can't seem to find the parts (o-rings and seals) to do this. Any suggestions on where to find them?<br /><br />Thanks
See more
Top