looking into a new coupler I have a 1987 mercruiser 260 h.p. alpha 1 cant find it in manual the research I did tells me its a new style coupler 18643A7 or 18643A5 does anyone know if this is correct. Any advice would help thank you
I cant align motor I get it exact then turn motor 180 and its way off kept trying and I believe the coupler is bad so I am buying one on ebay .my question is do I keep old coupler and align as close as I can and then replace coupler and yoke when it goes bad
just got my engine alignment tool, here is where I am at ,dropped in engine measured engine mount bolts to put in approximately at same height ,the alignment tool does go in with a little wiggling should it slide in wtih no resistance or should it slide freely thanks for any advice
when I took out old engine front motor mounts had some kind of caulk around lag bolts I am going to buy new lag bolts and washers but what kind of caulk should I use
ok just dropped in motor the bell housing rests on lock washers then bolt goes through bushing with steel washer on top is this right please tell me before I go any further thank u
my question is this, I have installed flywheel coupler on 1987 mercruiser 260 h.p when I took the coupler off the old engine I dont recall seeing any rubber bushings just the metal triangles at the bolt holes is this right, I used loc tite and torqued to 35 lb is this right
about to install engine due to cracked block just need to know how do engine mounts adjust it is off a 5.7 260 h.p 1987 the mount has a bolt on the top and bolt on bottom with a steel thingy that is bent over to stop bottom bolt from turning I will probably need to align motor after install...
I have a question regarding starting motor on ground I have water I have fuel but for some reason the battery is lagging it slowly turns over a couple of times then tahts it, its not the battery I thought it was at first so I took the one out of my truck and same thing then I hooked up both in...
hello again I am trying to start engine on ground before reinstall my question is, I know positive goes to coil is that where the purple wire is installed?
my question is this what kind of oil should I use in my 1987 5.7 mercruiser I know they recomend use quicksilver 25w40 but is it really necessary and if not what kind woud you recommend
I am reinstalling the flywheel on 1987 5.7 260 horse do I need to torque these bolts and also do I use any type of anti seize or thread locker on the bolts I will also be reinstalling the bell housing and have same question about that
I am swapping motors had to change oil pans and many other components I would like to start on ground before reinstall to check for leaks ,need pointers on where to connect wires and do initial startup I know where gas goes and water goes just not sure about electrical connections any help woud...
I thought I seen somewhere how to make a engine alignment tool does anyone know where I might have seen this I am almost ready to drop in motor this is the first time for me it seems pretty much cut and dry but should I start the motor on the ground first?and if so how do I do it
hi guys I have a question I am swapping engines I had to swap oil pans there is a plug I need to remove in the block for the dipstick tube I am trying to come from behind it using a screwdriver hitting it with a hammer so far no luck I am not really wailing on it is there another way before I...
