FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
In Other News . . .
You will notice a few enchancements to the forums to make your experience better. These include: Email Notifications, Thread Previews, Thread Starter Notation, and Emoji Options on the 'Like' icon. . .
Additionally, the merchant portions of the website have been updated and are now operational. . . . Check out iBoats for all your boating gear.
I think my trim sender is bad. I disconnected the wire that runs up into the motor and grounded it. The gauge responded by moving from pegged up to pegged down. Would this indicate a bad sender? Also, I'm having trouble locating the sender for this motor. The serial number is OG740775.
Thanks...
I have a Johnson GT 150 model # J150STLCOS Serial # J6130519. I'm trying to figure out if it has the 9 amp or the 35 amp stator. Is there any way to tell which, without pulling the flywheel?
Thanks in advance.
I have a 1986 Johnson 150. It runs perfect up to 3800 rpms. as soon as it gets to 3800 it starts cutting out, like a dead miss. I can throttle back a little and it runs fine. I recently replaced a power pack on one side to cure another problem i was having. Could this be a problem with the...
Let me start by saying that I am new to the site, and boat ownership. I don't know very much about out boards. I just purchased a 85 Ranger with a 86 Johnson 150. When i went to look at the boat the owner put the muffs on and fired it up. The motor started, but was doing this irregular sorta...
