FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
Since I removed the flywheel from the hub without marking it, how do put it back on and make sure I don't have any issues with it? Is it a timing thing I need to be concerned with?
Thanks.
I did not mark the flywheel, I did not know I wasn't pulling the whole piece off (oops). I have only removed flywheels from smaller outboards before so this one threw me off.
OK, well that's embarrassing. Can I use a puller (I have several), or do I need a factory tool of some sort? Will probably be the only one I ever pull off.
Hello folks,
I am trying to remove and replace the trigger on my 95' Mercury 40HP 4 cylinder 2 stroke but there is some kind of plate in the way and I cannot figure out how to remove it? My Seloc manual has no such reference to this part so I am stumped for now. Any help would be appreciated...
Thanks guys, sorry for the late reply. Sometimes I get lost in these forums (old guy here). I have removed the carb three times, soaked in carb cleaner and blew out every opening I could find. I'll pull her off again tomorrow and pay special attention to the path in the above pics. ABS wiring is...
Hello Folks.
I have a new to me 2006 MSF 18B2 that was running rough and the carb was leaking out fuel though what I guess is an overflow of some sort on the back side. I removed the carb, took it apart, soaked in carb cleaner overnight, reassembled with a few new gaskets and it is really hard...
Good day all,
I have an 88-89 Force 15 HP with a bad coil. The blue Prestolites on my motor have a brown and black wire and I'm having a hard time finding a replacement. I see some with blue and black wires but I'm pretty sure I read that those wouldn't work. Any help would be appreciated and if...
Good day, I am trying to install a new throttle cable on a 1987 Mercury 35 HP tiller and I cannot seem to get the cable wound correctly? Any help would be appreciated. Thank you, Mike
