Recent content by fish46

  1. F

    water in bottom cylinder

    I have a 90ETLJ 90hp 1986 Yamaha. Motor would run 5 minutes and temp buzzer would come on. Got home checked to see if t-stat was good found out it didn't have one. Then checked spark plugs and found water in bottom piston. Took cylinder head off to check gasket but can't find if water came in...
  2. F

    does anyone know what anodes are for?

    I have a 1973 Starcraft with a 70hp Evinrude 1973 (70473-m) I just got the not to long ago the motor turns on fine but when I put in the water it has a hard time turning on and wont stay on. I found an anode under the motor bolted on the transome and inside the boat on one of the screws has a...
  3. F

    70 hp Evinrude stalling

    I have a 70 HP evinrude (70473-M) on a starcraft aluminum boat. I had problems with it staying on and coming on. On the transom I found what I think is a external anode. I connect the wire inside to the motor and took care of that problem. Now the problem is that when I take off it stalls and...
  4. F

    1986 90 hp Yamaha

    i have a 90ETLJ 1986 Yamaha outboard and a part of the mid-section broke its were shift rod comes thru it broke from the bottom end and the whole motor moves I've been looking for a mid-section but can't find one so is there an other mid-section i can use like other hp or make that i can put my...
  5. F

    1986 90 hp Yamaha 90ETLJ mix screw

    does anyone know how to ajust it? been having problem on wot motor will stall. dont know if that has anything to do with that or what els can be my problem
  6. F

    1986 90 hp yamaha mix on carbs

    does anybody know how to ajust the mix screw on carbs how many turns out
  7. F

    What wire is for

    I have a 1974 Starcraft aluminam boat and there's a small block on the transom under the motor. Inside the boat there is a bear wire coming from the block does it go conected to the battary or where does it go
  8. F

    Do I have enough hp for sking and tubing

    I bought a 1974 strcraft with a 70 hp evinrude. I've been restoring the floor and still need a couple thinks before I can put it in the water. But my question is do i have enough power to ski or tube?
See more
Top