I have a 2002 Mercury 75hp four stroke. When I started it this morning it ran sputtered and died. Now it will not start and has no spark. The kill switch is in the correct position and the motor is getting fuel. It ran great last time out. Can someone help please.
I just purchaed a 1975 Fiberform 18.5Ft boat with a 120 OMC outdrive. I realize that the drive is designed to operate in the full down position. My question is can the drive be operated in a partial tilt position at low rpm when navigating shallow water or backing off a shore. I have not put the...
Hello,<br />I just purchased a 1975 Fiberform 18.5 Ft with an OMC120 and GM 4cyl. I have purchased the manual and the boat is in good condition for its age. I live in Montana and boats are not used much and in fresh water only.<br />If anyone out there has any thoughts or tips about this setup...
I just got a new carb kit for my 1965 60HP 4cyl Johnson. It did not come with any spec sheet. Does anyone know what the float level should be set at. Any other tips for this carb would also be greatly appreciated.<br />Thank you,<br />Dan
I have a 1965 Johnson 4cyl 65 hp outboard. It runs great but when I come back to the dock there is an excessive amount of a white oily substance that comes out of the motor. Once out of the water I can see it leaking out of a small hole on the left side of the motor near the cavitation plate. It...
I have a 1965 Johnson 4cyl 65 hp outboard. It runs great but when I come back to the dock there is an excessive amount of a white oily substance that comes out of the motor. Once out of the water I can see it leaking out of a small hole on the left side of the motor near the cavitation plate. It...
