I have a question for all you JonnyRude owners out there.
I just bought a 1995 Johnson 115hp Faststrike, all the compression works out and the motor looks in great shape.
The pervious owner still had the VRO oiler system connected and my question is should I disconnect the oiler as insurance...
I wonder what prop would be best for my outboard I am currently running a _13 x 19 - k Stainless (pretty dinged up)___ on my 115hp 2 Stroke Yamaha the motor is on a 1994 Jetcraft Pro-stealheader 18ft fully welded hull with a less then 6 degree dead rise ( Made for a jet pump). I always run at...
I have a 110hp v4 Evinrude
I was running a mild load this weekend and the boat was running fine around 4200 to 4500 RPM . Running for about 30 Minutes I hear a clicking and decided to back off the throttle and shut the engine down I took the hood off and checked for any signs of overheating...
I have a 110hp v4 Evinrude
I was running a mild load this weekend and the boat was running fine around 4200 to 4500 RPM . Running for about 30 Minutes I hear a clicking and decided to back off the throttle and shut the engine down I took the hood off and checked for any signs of overheating...
I recently pulled all my plugs on my rude and saw that there was water on the plugs not much just a little
I haven't done a compression test but the last time I was out the motor ran like a champ
Could it be a head gasket? I'm not sure because its in all 4 plugs
Could it be a exhaust gasket...
I have a couple questions about running these 2 stoke monsters
I run her at about 3/4 throttle 4500 RPM for fuel economy is that bad? I have heard that if you dont run at WOT you get alot of carbon build up resulting in stuck rings and KA-boom
What is the idea behind WOT or just getting on...
Can't figure out what's wrong
Could it be a fuel issue? I've checked all lines and replaced the inline filter
I've checked the power head gasket and no leaks
Not sure where else to check?
Thank you
my 1986 90 hp evinrude did not come with a tach. I wanted to know if I have a siginal before I purchase one.
1. My battery is charging
2. My test light goes off when I test the gray lead from the control box.
Is there anything to test to see if I have signal off the powerhead?
What tools...
I recently attained a QuickSilver PARA LIFT Hydraulic Jack plate I was wondering if it would be worth it to run on my 1993 17.5 ft Tracker Magna Dual console. I am running a 90hp 1985 evinrude body with a 1995 OMC 115hp powerhead at 7000ft elevation at Navajo Lake, New Mexico.
I was wondering...
I have a 1985 90hp evinrude VRO removed I bought a Moeller canister style water separator marine fuel filter Model #33323-10
I was wondering does the prime bulb go before or after the filter? does it matter?
Will i put too much stress in my fuel pump with this filter?
Thank you
Can a Mid 90's 115hp OMC engine fit in 1985 VRO 90 hp ? they are both bubble backs. This is a complete motor swap not just the power head.
Does anyone have any opinions?
how much power will this make if it works?
Is a cowling going to be an issue? Will it fit with no problems
I am having a hard time removing the starter to tis motor does anyone have any pointer on this.
Do I have to remove the starter to get the carb?
I am replacing the impeller and rebuilding the carb. I think i have to remove to starter first then the carb then shift linkage bolt of the lower...
