FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
In Other News . . .
You will notice a few enchancements to the forums to make your experience better. These include: Email Notifications, Thread Previews, Thread Starter Notation, and Emoji Options on the 'Like' icon. . .
Additionally, the merchant portions of the website have been updated and are now operational. . . . Check out iBoats for all your boating gear.
Hello all
my question is in regard to the throttle assy, made by omc well under the ignition key there is a black knob u can turn. Is this for timing ???
silly question i know but this is my first small boat with an outboard
thx for the info
1985 evinrude 50hp o/b
after cleaning and rebuilding both carbs i still have the crank no start.
engine does start fine with a spray of FUEL mixture (as advised) in one carb.
today i noticed something while turning the ign key i must have pressed it inward and heard a click....im a noob at...
after the boat sits a few days its seems to crank but no start. it does crank very fast and has has good spark so i went to fuel what i found is this,
with a small shot of starter fluid it fires right up then stalls out. i pump the primer ball off the fuel tank and try it again...same no...
hello all
im very new to this site so bear with me .
the outboard is a 1985 evinrude 50hp 2 stroke. the motor has been sitting a year or 2. Last year i replaced the impellor assy as directed. started the motor and the water was coming out of pee hole just fine. this year i set up the muffs...
