I have a 71 evinrude 40hp, I have put a new impeller in it. It seems to be getting to hot and I was wondering where the thermostat is located on this model. Also is it possible that the key for the impeller sheared? Not sure where to start. Any help would be appreciated !!<br /><br />thanks
I am trying to hook up my controls and I am needing to know where the 3 wires go. There are only 3 wires....BLACK, ORANGE, YELLOW.. in the harness that goes from the controls to the engine. And where does the kill switch wire (orange wire in power pack) go? Thanks in advance.
I am trying to hook up my controls and I am needing to know where the 3 wires go. There are only 3 wires in the harness that goes from the controls to the engine. And where does the kill switch wire (orange wire in power pack) go? Thanks in advance.
I am replacing my power pack. The old one was off the motor when I bought it. It is a 79 mercury 7.5 horse. I know the brown and white wires connect to the leads coming from the stator and the brown one connects to a terminal on the coil with the extra terminal. There is also a ground (where...
I am replacing my power pack. The old one was off the motor when I bought it. It is a 79 mercury 7.5 horse. I know the brown and white wires connect to the leads coming from the stator and the brown one connects to a terminal on the coil with the extra terminal. There is also a ground (where...
I am replacing my power pack. The old one was off the motor when I bought it. It is a 79 mercury 7.5 horse. I know the brown and white wires connect to the leads coming from the stator and the brown one connects to a terminal on the coil with the extra terminal. There is also a ground (where...
I have a Force 85 horse on a 15 1/2 foot v-hull (Winner brand 69 model). The boat is rated for a 8o horse. The nose of the boat seems to be to low and drags the boat speed down. Could it just be the older design of the hull that is the problem? Would I need to tilt the motor back a natch on the...
What should I consider when choosing a prop? I have a Force 85 horse and a Yamaha 50 horse that I will be buying props for. Is it the weight of the boat, top end/low end speed, pulling a skier....etc? Thanks for any help with this.
I have a 89 model 50 horse yamaha. It got hot and two cylinders read 90 pounds compression the other cylinder is 120 pounds. Is it worth rebuilding? If so should i bore all three cylinders or just the two?
