Good day everyone. I came across an old Honda outboard, eight horsepower, and the power head was salt encrusted so much that water would not circulate. The specs on it were a BF8AHLA, frame id# BACL 1000542. Model year 1987.
I removed the power head, and replaced it with a 10 horsepower head...
I "rescued" an 8 hp Honda outboard, pre 97. It had been submerged in salt water and left laying on the beach for who knows how long. I got it started and it overheated instantly. I turned it off immediately and tore into it. Discovered that salt had clogged all of the cooling passages. When I...
Re: Volvo U-joint and shaft seized in motor
This is what I made and used successfully on my 280 with the same problem. I removed the upper gear unit as far as I could, strapped the bellows and got it out of my way, then I hammered out the outermost ujoint bearings and "cross piece"and...
I need to know if there is any kind of lube or sealer that has to go on the 2 large "donut" rubber gaskets in and out of the transom when installing the engine ( cantilever mount-270-289):confused:
Penta p/n 804190 nomenclater "rubber ring"
Thanks in advance
btw, My ujoints were stuck on the...
I am trying to find a way to remove the lower case, the shift rod is preventing this. I need to rplace shaft seals after checking pump impellar (shaft seal parts at the motor end fell out during the check)
Help!
