Recent content by Froeman

  1. F

    How tight should the prop nut be?

    I replaced the prop on my 2008 Larson 180 with Volvo 3.0 with SX drive (21p 3blade to 20p 4blade). Bought a Michigan wheel prop with hub kit that came with new washers etc. when I first installed I didn't think there was any "play" (front to back) but now there appears to be some, barely even a...
  2. F

    Synthetic or mineral oil in low-hours motor

    Volvo 3.0 bought used with 41 hours. Mechanic says use mineral oil until the motor is a bit more broken in. Agree or disagree? Opinions please.
  3. F

    Volvo 3.0L power mod increase?

    Are there any simple cost effective engine mods to pull more power from a 3.0L Volvo motor? 2008 model on 18" Larson. 53 hours on the motor & drive. Everything original. Thanks!
  4. F

    BOLT found in bilge - need help identifying please

    I have a 2008 Larson 180 with a 3.0L Volvo Penta (GL?) motor. SX outdrive. There are 53 hours on the boat. I found this bolt lying in my bilge a few days ago. I only had time for a quick visual inspection, but I can't see any obvious places where a bolt is missing. The boat runs fine (as...
  5. F

    Swim ladder - RUST - on 2008 Larson 180 !

    I have a 2008 Larson 180 that spends most of its time on the trailer. When we boat/swim (using the swim ladder extensively) I notice rust coloured (yes, Canadian spelling of "colored") water aruond the ladder / screws. I was going to remove the ladder, but when I turned the screws, they just...
  6. F

    3 blade to 4 blade

    Hi folks. 2008 Larson 180, Volvo 3.0L with stock 14.3 x 21 prop (3 blade). Want better hole shot for skiing, and would like to plane at lower speeds. My top end is perfect for what I need (about 42MPH on GPS, at just over 5000 RPM). I understand that moving to a 4 blade will provide better...
  7. F

    Volvo 3.0 what kind of winter antifreeze?

    I have read all of the discussions in the winterization forum, and I'd like to know what type of antifreeze to use AFTER I drain my block/manifold. I have used RV antifreeze on previous watercraft but I'm wondering if there is anything with an anti-corrosive that might prevent or reduce rusting...
See more
Top