I would like to install a trim gauge on my 21' Tidewater bay boat which is powered by a 2007 Suzuki 140. I've found the trim gauge I need online, but do I really need to buy the harness? Or are the trim indicator wires already built into the engine's wiring harness and just one of those unused...
I am working on buying an '07 Tidewater 21' BayMax powered by a very low-hour 140 HP Suzuki. I saw the boat last Fri. and liked it, so we took it out yesterday for a sea-trial.
While running it, I noticed it put up allot of spray beside the O/B's mid-section until the motor was trimmed up...
The '00 Key West 1720 center console with a 115 Evinrude Ocean Pro I bought last year came with a Michigan Wheel 14 x 19 aluminum. I recently purchased a used 13 x 19 OMC Stainless Steel a few weeks ago and then I found (what I thought was) a deal on a NEW OMC stainless 13-7/8 x 19 so I picked...
I was told by a mechanic in '09 that when they removed the l/u of my '06 Suzuki 200 to check for another problem they would replace the impeller while they had it out. Well, I went to change it this week and found this...
I don't think it was changed ~18 months and 100 hours ago!
Do I...
My '98 Evinrude Ocean Pro 115 has developed a leak in the lower unit. I bought the motor in Sept. and replaced the gear lube then. What came out looked clean and I even checked it several times since I changed it and no problems until two weeks ago.
I took it to a local shop and they...
This motor is mounted on a Scout 152 sportfish and I've owned it since early spring of this year. I've run it quite a bit this summer. After purchasing it, I rebuilt the carbs and followed the synchronizing and timing adjustments per the service manual. I removed the VRO and am running...
