Update: got the gimbal bearing and bellows replaced. New u-joints, exhaust bellows, trim transducer, and fresh water intake hose. Job wasn’t really too bad. Took a couple days.
Question: is there a breakin period on that gimbal bearing? Since the driveshaft spins all the time, should I throw it...
Got it, and thank you very much for pointing out a couple things I need to inspect. I suspect that this shaft unit has been replaced previously ... based on the overall condition. The shaft has (2) o-rings that seal, presumably, to the inside of the gimbal bearing, I ordered replacement o-rings...
Update: Got the drive removed. That wasn’t really that bad. Ordered bearing, u-joints, both bellows, trim transducer. Discovered 1 missing bushing, so ordered that too.
Quick follow up question: on the SX drive, should I replace the ujoints with the shaft in the upper unit, or disassemble the...
Well … I bought my first boat …
1997 Four Winns Horizon RX - 4.3 GL, VP Cobra SX outdrive. 18’ open bow. The HOBBS meter says 740 hours, but it doesn’t work, so it has at least that on it. It is a
Sorry if I’m going to ask a bunch of dumb new guy questions that have been answer a hundred times...
