Recent content by galillo

  1. G

    125hp overheating

    Have a Force 125ho 1989 and is getting hot, I change the impeller and water is running good, the question that I have is that if the frywheel have some dents one is aorund 1.5" and another about 1" trying to pull this out, this can cause the overheating.? I know the motor is clean inside water...
  2. G

    tilt and trim problem 125hp

    I guys I just have one question, on my force 125hp 1988, when I pull it up at few minutes start to coming down alone, so I just need to know if this problem are the piston or the pump? Thanks
  3. G

    125hp 1988 force heat problem

    Hi I use my boat this yesterday and the heat alarm come on, the impeller is new and is working i can see the water coming from the holes. did someone know if the tube coming in to the housing of the impeller have to have some kind of o'ring or something. mine is just the tube go in to the...
  4. G

    temp overheating force 125hp

    Hi went to a trip yesterday on my bayliner capri cuddy 1988 motor Force 125hp 1988, after a while pulling a tube the temp. alarm whent on, I turn off my motor and wait for a while until cool down then start the motor again and get back on road butt still seem some steem coming from the holes...
  5. G

    kicker motor for a Bayliner capri cuddy 19'

    HI I want ti install a kicker motro in a Baylinner capri cuddy cabin 19.5" my mechanicall tell me that 15hp is good enough for this boat as a kicker, I only want to be sure when I get inside the ocean and I don't thrust my force 125hp motor, any one have idea if I can do that on this baylinner...
  6. G

    trigger conection

    hi I just receive my new trigger for my motor Force 125hp 1988 serie c but this trigger has only 5 cables 1 for each cylinder and the ground my old trigger has 2 cables for each cylinder and the seloc manual do not tell me nothing about it, any ideas what I have to do. Thanks
  7. G

    force 125hp serie c 1988

    Hi I went to the river this morning to have some fun with my family, the motor star right up and i hit the gas any jump fine but after two seconds the motor loss power and never run fine again about ten miles was the faster some times if I drive along I get around 25 miles after a wile diving...
  8. G

    steering tube force125hp 1988

    I someone have idea where I can buy the steering tube that goes on the motor to hold the steering cable. this one have the 2 nuts and the greaser. Thanks,:)
  9. G

    125hp 1988 loss of power

    Hi I went to the river this morning to have some fun with my family, the motor star right up and i hit the gas any jump fine but after two seconds the motor loss power and never run fine again about ten miles was the faster some times if I drive along I get around 25 miles after a wile diving...
  10. G

    125hp coil issue

    i just bought a new coil CDI 182-4475r for my force 125hp 1988 c but is also not working I check the signal coming from the switch box and is fine, but when i connect the cable to the coil the signal is almos gonne i have not idea what is going on, any ideas.? Thanks:)
  11. G

    force 125hp 88

    Hi I just buy a bayliner capri 19' with a Force 125HP 1988, i don't have idea how much water how to come out for the pin holes because most of the water come out from the exhaust and only a little bit for the holes on the middle, i read alot about the pressure valve on the water maniful left...
See more
Top