When re-assembling after a difficult water pump rebuild, I messed up coordinating the cam rod and shift rod orientation. Both rods are in place and connected at the shift rod joint, but I don't know what gear the system is in currently, nor whether the cam rod is facing in the wrong direction...
I need to change the impeller on my 2-year-old Tohatsu 6HP SailPro.
I have the Service Manual and have followed the instructions.
I removed the rubber grommet and loosened the shift rod joint bolt, and the two rods can now move independently and freely.
I have removed the two gear case...
I am connecting my SeaTalk ST60+ devices to my new A70D chart plotter. I am installing and wiring the NMEA0183 data interface, new transducer, etc., and have one minor question.
To make the install work, I need to extend the Power cable that comes from the three daisy-chained ST60+ devices. The...
After replacing a worn impeller, re-assembly became impossible because the drive shaft won't insert all the way. I have tried everything I can think of.
This morning I tried to insert the drive shaft ONLY without even a bothering with the shift linkage clamp. I turned the lower unit 90 degrees...
