Recent content by gary clune

  1. G

    Trolling motor plug & momentary on-off switch installation

    Silvertip, hope you're listening... I'm helping a friend with the aforementioned. He has a 12v MinnKota hand controlled trolling motor with 2 batteries wired in parallel. There are 2 wires from the batteries (bilge) to the t/motor plug (bow). He wants to replace the existing, worn out, 2 wire...
  2. G

    135 HP Cylinder Heads Interchange

    Will the cylinder heads from 1974, 75, or 76 135 HP fit my 1973 135 HP? May need to replace the port side & can't seem to find any in good condition. Thanks
  3. G

    Engine Core Plug Missing

    Just purchased a 1973 Evinrude 135, Model #135383M, according to the bracket data plate. Wanted to verify the model # with the engine core plug, but it's missing. The motor does have the bubble back exhaust, so it's probably the original powerhead... a definate maybe. Any other way I can tell...
  4. G

    1976 Evinrude 115 & 1992 OMC Remote Control

    Have a 1976 115 Evinrude that I've inherited. Motor has not been used in years, & no remote control with it. Was given a remote control of unknown origin that's been painted. Haven't been able to find any ID numbers on the exterior. Round decal on shift lever(?) reads "OMC" 3 times in a circle...
  5. G

    Skeeter SS90 enlarged livewell

    I previously posted this in the Skeeter forum, but had no takers. Probably should have posted here to begin with. Anyway, I have a 1996 Skeeter SS90 bass boat. I would like to modify the rear livewells to accomodate the type of fishing I do. Currently, there are two smallish livewells side by...
  6. G

    ss 90 enlarged livewell goal

    I have a 96 ss 90 that I would like to modify the rear livewells on to accomodate the type of fishing I do. Currently, there are two smallish livewells side by side, just fwd of the bilge. I would like to make these two livewells into one by cutting and joining them on their inboard sides. The...
  7. G

    skeeter ss 90 jackplate

    what are the pros/cons of installing a jackplate on a ss 90 with a 90 hp engine? does anyone have any thoughts regarding setback distance? i previously posted this in the general forum, before i realized there was a skeeter forum. thx for any help.
  8. G

    skeeter ss 90 jackplate

    anyone know of any pros or cons for installing a jackplate on a skeeter ss 90 16 ft bass boat with 90 hp motor? also, any thoughts regarding setback distance?
See more
Top