Recent content by Gary H NC

  1. Gary H NC

    Huge left pull when getting on Plane

    That tab is adjustable and some have to be removed to access one of the other bolts that hold the lower unit on.
  2. Gary H NC

    95 Bayliner Remote Controller replacement

    They make updated versions.... The one in the link I posted should work just fine..
  3. Gary H NC

    95 Bayliner Remote Controller replacement

    Many controllers will work just make sure they are for the same cables...Merc control. Does it look like this for example? https://www.amazon.com/Mercury-Quicksilver-Parts-8M0011213-CONTROL/dp/B00475GFM6
  4. Gary H NC

    1980 3.0L strange overheat issue

    That is good! I hope it solves the over heating problem...save you about 400 bucks!
  5. Gary H NC

    1980 3.0L strange overheat issue

    Wow! A ton of rust! Maybe time to hunt a new manifold.. I know they make them for the old OMC Cobra but not sure on the Stringer drive.. What engine is it? Did some looking and they do make a replacement for the 3.0 Stringer manifold.
  6. Gary H NC

    Help! 1968 33 HP Evinrude

    I tried but having problems transferring them from my phone to something I can post on here! I have a video of it running and shifting on first start up.
  7. Gary H NC

    Dual cable rotary steering

    That would be less expensive option for sure than hydraulic!
  8. Gary H NC

    Help! 1968 33 HP Evinrude

    Those parts were expensive for that 1968...Had to put all new bearings and a gear set.clutch dog and all in it.
  9. Gary H NC

    Help! 1968 33 HP Evinrude

    Time to get on my Chris Craft next after I do steering and Impeller and carbs on a 40 HP Evinrude. people need to learn to run non ethanol gas and run them out of gas before Winter!
  10. Gary H NC

    Help! 1968 33 HP Evinrude

    The little 33HP was delivered today..Boat purrs like new. Rebuilt gear case,all new fuel lines,pump,tank, and rebuilt card...bump the key and it fires right up. The boat is a 1968 and looks new. The owner stores it in a climate controlled garage...That thing is really nice!
  11. Gary H NC

    Help! 1968 33 HP Evinrude

    I have 2 new ones in the box for my 175 and 6 carb kits...lol. Stocking up on parts as they are getting more expensive for these older engines..
  12. Gary H NC

    Help! 1968 33 HP Evinrude

    The pump on this 33HP looks like the ones on my 175...different part numbers but looks just like it..
  13. Gary H NC

    Help! 1968 33 HP Evinrude

    Thanks everyone! Compression is 120 on both cylinders cold. Good spark but was getting no fuel. Replaced all of the fuel lines and the owner told me to just replace the fuel pump.. Got the carb on the bench and it was in need of major cleaning.. I got the rebuild kit and about ready to bolt it...
  14. Gary H NC

    Help! 1968 33 HP Evinrude

    Thanks...Got it finished and holds pressure... On to rebuilding the carb and replacing the fuel pump and all of the lines..
  15. Gary H NC

    Help! 1968 33 HP Evinrude

    Thanks Guys! Just came back in from the shop...I put a fatter O-ring in it and it passes a pressure test now! Fun tearing it back down for that! It was the original OMC part number so not sure why it did not seal... Yes...The o-ring fit but the inside diameter must have been off is all I can...
See more
Top