I need to replace the two trim solenoids on my 1986 150XR2 Merc. Is there a trick to get them out? It's a tight area there. Any advice or a brief procedure is appreciated.
Anyone run a Tempest Plus with the PVS holes completely open? The reason I ask is because My 86 Procraft 1750V Fish & Ski is a dog out of the hole even with the size "L" PVS plug. When I had it on the water for the initial test run, I did not think to completely remove them and give it a try...
Just had a new hub pressed into my 23P Quicksilver that helps a 150 Merc propel my 17.5' Procraft. I have a few Questions:
1. Is there a procedure I should follow before I run it WOT?
2. How much torque should I apply to the prop nut?
Thanks in advance.
A friend here at work is letting me try his brand new 23P Tempest Plus on my 86 Mercury 150XR2. After spinning the hub on my old Quicksilver 23P I am looking to try something newer.
Anyway, I installed the Tempest Plus, torqued it down to 55lbs, and I have about 1/4" of clearance between the...
A guy here at work has a brand new Tempest 23P Prop for sale and I am thinking of buying it. Included is a Flo-Torq II hub with part number 835257A6. I was told from one source that this part number has been superceeded by 835257Q6. The guy selling the prop bought it years ago as a spare for...
I just bought a 1986 1750V with a 150 Merc XR2. The boat runs and drives like a champ but needs a few things to make it more like new. The main thing I want to repair first is the floor. A soft spot has developed in the back floor area where the deck drain is located. The soft area is about...
This is my first post and I look forward to chatting with you guys in the future.
Tomorrow I am going to perform a compression test on an 86 Merc 150XR2 that I will hopefully buy. While I am at it, I will go back with fresh plugs. What brand and part number do you guys recommend?
Thanks:D
