Please help.............no experience here.
I have removed the locking screw with an allen wrench and the threaded cone. Under the cone was a large spanner type washer which lifted out. The next thing as is appears is the prop itself. Do I need some sort of puller to remove the prop from the...
My son and I have purchased a Bayliner Santiago. It has a chevy 350/volvo 280 out drive. I believe the boat is a late 1990's model. The hull number is BLBA45SF0379-9. We are in the process of shaking down all the problems and potential problems we can find before launching and running the...
I have a classic bass boat that I garaged 10 years ago because of transom and floor problems. I hoped to restore the boat. I screwed up and negelected to run the motor once a month and did not follow proper long term storage procedures either. When last used the motor ran well. It had a...
My son's Evinrude has oil leaking from under the flywheel of the engine. The oil pools on top of engine block right under the flywheel. What could possibly be causing this? Any guidance would be appreciated. Thanks, George Santee, CA
My son's Evinrude has oil leaking from prop area after use on the wate. We just noticed a small spot on the driveway under the motor. It appears to be coming from the exhaust. We also noticed oil up under the flywheel of the engine. Could the two problems be related? We knew the leak under...
I have a 1974 vintage bass boat that I am about to restore. It has a 1974 Evinrude Triumph 70 hp engine that needs to be removed. The engine block has two lift rings bolted to the block that appear to be for either removing the engine block or perhaps for lifting the entire engine.
Can anyone...
My son and I have an older 16ft Smokercraft aluminum skiff we use for both freshwater and inshore saltwater fishing. We are trying to find a good radio/antenna combo that will be reliable to 20 miles without having to have a tall antenna. Space in the boat is limited and there is no above...
This motor has been fine since we purchased it two years ago. We use it in fresh and salt water. It has just started running the start battery down and also showing obvious electrolysis on the motor shaft housing and lower unit. Could an alternator be causing this?
Please advise what I...
I have a Power Drive ser # MKAC2203267. My first question is: Does anyone know what year this motor is?
It's on a boat my son just purchased and in checking it out, we find that when hooked up to a fresh battery we have prop rotation but no steering. How can we determine whether the problem...
Does anyone have the transom weight for a 1974 evinrude 90 hp with power tilt and trim. My boat is rated for a 90 and I'm going to an etec and need to know the original weight rating to match it to the closest etec model
