Recent content by gerber

  1. G

    1985 150hp v6 relief valve

    Does anyone have a clear photo of a non broken trim relief valve?? mine doesnt appear broken but cant tell it has all 3 o rings and then 1/8inch tapered squared tip in front of smallest oring
  2. G

    merc 85' 150hp trim fluid removal

    i am trying to get all the 2cycle flushed from the trim unit. what is the best way of doing this, i can still hear some fluid inside?? secondly; once i refill with motor from locked up position ,when should you release the lock and start to bleeding system? this is my 3rd try and still have...
  3. G

    1985 150hp trim not bleeding

    it wont go up or down very far from the bottom up or the top down it moves a few inches from extreme ends. the motor changes pitch as it stops moving. The 2 small pistons seem to work the best up and down but slow , it seems to be main piston fluid isnt getting in or out fast enough or...
  4. G

    trim not able to bleed 150hp

    1985 150hp , i replaced the motor/pump assy (one piece) and replaced the seals in the main ram piston. I cant get it to bleed properly, if it is all the way up i can lower it a few degrees then back up but i cant seem to get it up from all the way down. That is if i use the emergency valve to...
  5. G

    1985 150hp trim piston removal

    hi, i have the main trim piston out i managed to remove the top spanner seal bolt and have the shaft on the bench. how do i remove the ends on the main piston shaft to replace the small top shaft seal??? thanks dave
See more
Top